Line · Line

Ultherapy and Thermage Together: Can You Combine Them?

BASE Dermatology 2026. 10. 20 READ 27 MIN
Ultherapy and Thermage Together: Can You Combine Them?

The director of BASE Dermatology Clinic holding a handpiece and treating the face of a patient lying down, with a monitor unit beside them.

Yes, you can have Ultherapy and Thermage together, either back to back on the same day or in separate sessions a few weeks apart. Ultherapy PRIME lifts the SMAS layer to sharpen your contours, and Thermage FLX then firms the dermis above it. Working together, the two deepen the lifting effect and help it hold longer. Before you book both, though, a board-certified dermatologist should confirm that your face really does need treatment on both layers.

Can Ultherapy and Thermage Be Combined? The Short Answer First

  • Yes, you can. Whether two treatments get in each other’s way comes down to two things: how deep the energy travels and which layer it heats. Ultherapy uses focused ultrasound to heat the SMAS, the deep fascial layer. Thermage uses radiofrequency to heat the dermis. Neither one cancels the other out.
  • There’s a genuine reason to pair them. Ultherapy lifts the deep layer and defines the contour. Thermage then tightens the dermis sitting above it. The immediate tightening and the collagen response that develops over several months overlap, so results tend to hold longer than with either treatment alone.
  • The condition is that both layers need work. If only one layer has lost its firmness, one treatment is enough. I always check this before I recommend both.

For a closer look at how the two devices differ in energy type and target layer, see Thermage vs. Ultherapy: The Real Difference, From How They Work to What They Target.

What We Check First: Which Layer Is Sagging?

I ask two separate questions: does this face need Ultherapy, and does it need Thermage? Only when the answer to both is yes does combining them make sense.

Ultherapy is the right fit when the SMAS layer has lost its tension. That’s the person whose jawline is blurring, who is developing a double chin, or whose cheeks are starting to drift downward. Thermage is the right fit when the skin surface itself has lost elasticity: more fine lines, stretched pores, rougher texture. Try this in front of a mirror. Gently push one cheek upward with a finger. If your contour changes, the problem sits in the deep layer. If the fine lines and pores look the same even when lifted, the problem is in the dermis. If you notice both, you’re a candidate for the combination.

During your consultation, I start by checking the thickness of your skin, fat, and SMAS with the real-time ultrasound imaging built into Ultherapy PRIME. That tells me where to use the 4.5 mm and 3.0 mm transducers. With Thermage we can adjust the energy but not the depth, so the balance between the two is set on the Ultherapy side. If you have thin skin and little fat, there are fewer spots where the 4.5 mm depth is useful, and I may scale back the Ultherapy portion. If you have thick skin and deep sagging, Thermage alone won’t get you there, and I increase the Ultherapy portion.

If only one layer is the problem, I don’t recommend both. I recommend the one you need. Combining them is the option for when both layers need treatment. We settle this distinction in a one-on-one consultation before building your plan.

Brand mood image

Why Do Results Improve When Combined? Heat Accumulation and Collagen Response

Both devices use heat to contract existing collagen and trigger new collagen production. Because they reach different layers in different ways, each one fills in what the other leaves out.

The principle behind every energy-based treatment is simple. Once tissue reaches a certain temperature, existing collagen contracts immediately, and new collagen forms over the months that follow. What differs is how deep each type of energy penetrates and how it’s delivered. Ultrasound concentrates heat on a single point, the way a magnifying glass focuses light, creating tiny coagulation points in the SMAS. Radiofrequency heats the entire dermis as a broad plane. In short, Ultherapy treats the deep layer point by point; Thermage treats the dermis as a sheet.

This is where the case for combining them comes in. Ultherapy creates coagulation points deep down to pull the structure upward, and Thermage raises the temperature of the dermis above it to set off a broad collagen response. When you add heat stimulation at a different depth to tissue that has already begun a thermal response, the reaction can be stronger and last longer. This is a pattern we see regularly in clinical practice. A split-face study published in Skin Research and Technology in 2023 treated one side of the face with focused ultrasound alone and the other with ultrasound plus radiofrequency, with blinded evaluators judging the results. The combined side showed greater improvement. The study didn’t use the Ultherapy PRIME device itself, but the combination rests on the same principle.

Overlapping heat isn’t always a plus. If heat overlaps within the same layer, burn risk goes up, and even across different layers, the total heat load on your face increases. That’s why I distribute the energy and shot count for each treatment zone by zone. I’ll come back to these boundaries in the precautions section below.

Dividing the Work: Ultherapy for the Jawline, Thermage for Fine Lines and Pores

Overlapping areas go to whichever device does the job better, and each device focuses on the zones where it’s strongest. That way we can drop the extra shots you’d otherwise need when one device is pushed to do everything.

Ultherapy’s strongest zones are the jawline, double chin, and sagging cheeks, where the SMAS needs to be pulled up. Thermage’s strongest zones are fine lines, pores, and skin texture, where the dermis needs tightening. For areas both devices reach, like overall firmness, I decide which to lean on based on skin thickness and how far the sagging has progressed. For the criteria I use to assess jawline sagging, see the Jawline Lifting page.

Dividing the work changes how the shots are spent. The repeated shots you’d otherwise lay along the jawline with Thermage alone, or the shots you’d push into fine-line areas with Ultherapy alone, can be cut back. Each treatment’s shot count can then be adjusted somewhat, and the total heat load on your face is lower. I plan the exact shot count based on your skin.

Three combinations come up often in my clinic. First, for someone with a blurring jawline and reduced firmness across the cheeks, I concentrate Ultherapy on the lower face and jawline and use Thermage on the dermis of the cheeks and around the nasolabial folds. Second, for someone worried about a double chin who also has enlarged pores and rough texture, I use Ultherapy under the chin and Thermage to heat the dermis evenly across the whole face. Third, for someone whose main concern is fine lines around the eyes and forehead, with a jawline that’s only just starting to sag, I make Thermage the centerpiece and use Ultherapy only as needed along the jawline. For how pores and texture change over time after Thermage, see Pore Changes After Thermage: When They Start and What to Expect.

Powder room at BASE Dermatology Clinic with three sinks, a mirror, and wooden cabinetry under indirect lighting.

Order and Spacing: Same Day or Separate Sessions, and Which Goes First?

On the same day, Ultherapy goes first, followed by Thermage. If you split them into separate sessions, the usual approach is Ultherapy first, then Thermage one to two weeks later, though the order can be reversed depending on which layer started sagging first.

The main reason to do Ultherapy first is that following it with Thermage lowers the risk of surface burns. Delivering heat from the deepest layer upward also makes the outcome easier to predict.

Some people do better splitting the sessions. If your skin is thin or sensitive, if you’re short on time that day, or if you’d rather see how one treatment turns out before committing to the next, we schedule them on different days. In that case, which goes first depends on which layer started sagging first. If your jawline went first, start with Ultherapy. If skin elasticity declined first, it’s fine to start with Thermage. I set the interval for after the redness and swelling from the first treatment have settled and your skin has stabilized, and I decide the timing after examining your skin.

Results and Limits: When They Appear and How Long They Last

Right after Ultherapy, you may feel a light tightening. Visible changes begin around week two, followed by a collagen response that unfolds over several months. How long results last depends on how far your aging has progressed, so maintenance sessions are typically scheduled anywhere from every 6 months to every 1 to 2 years.

The two treatments show results on different timelines. Ultherapy produces contour changes relatively early through SMAS contraction, while Thermage gradually improves firmness and texture over the months it takes dermal collagen to rebuild. When combined, the fast change and the slow change link up: contours take shape first, then the skin firms up behind them. Repeat sessions are typically every 6 months if aging is more advanced, or every 1 to 2 years for upkeep.

That said, combining them doesn’t double the effect. The improvement seen in studies was judged by evaluators using photographic criteria, and the degree of improvement differs from person to person. Each device acts only on its own layer, so the value of combining them lies in complementing each other, with no layer left behind.

The limits are just as clear. If you have severe sagging, substantial fat under the chin, or a lot of loose skin, the expected range of improvement is limited even with both treatments. Those cases call for a separate conversation about fat-reduction treatments or surgery. Conversely, if hollowing in the cheeks is a bigger issue than sagging, restoring volume comes first (see Volume & Contouring). Whether it’s sagging or hollowing is determined after a dermatologist’s diagnosis.

Side Effects and Precautions When Combining: What to Watch for When Heat Overlaps

Common reactions are redness, swelling, tenderness to the touch, and temporary tingling. When both treatments are done on the same day, these can be a bit more pronounced or last a bit longer.

Side effects differ slightly between the two treatments. After Ultherapy, you may see bruising, tenderness when pressed, or a tingling sensation under the skin. After Thermage, redness and mild swelling are common. Rarely, there can be burns or blisters, or a temporary uneven, lumpy feel beneath the skin. During treatment, I monitor skin temperature and response and adjust the energy as we go. Right afterward, we cool and soothe the skin, and if any adverse reaction appears, we manage it with prescribed ointment and follow-up visits. Areas both devices reach, like the border between the jawline and cheek, are prone to heat buildup, so I adjust shot spacing and energy separately there.

Doing both on the same day is more tiring and uncomfortable overall. That’s why the plan calls for generous numbing cream, a rest break between treatments, and thorough cooling. Aftercare is the same for both. Skip saunas, heavy drinking, vigorous massage, and hot compresses on treatment day, and be more diligent than usual about moisturizing and sun protection.

Some people should avoid or postpone the combination. If you have acute inflammation or an active skin condition, are pregnant, have a pacemaker or other implanted electronic device, or metal implants, or have recently had fillers or a thread lift, a dermatologist must confirm the timing and whether treatment is appropriate for you. During your consultation, please disclose every previous treatment and every medication you’re currently taking.

Skin cross-section infographic comparing the treatment depths of Ultherapy and Thermage: Thermage works across a plane in the dermis, while Ultherapy targets points in the SMAS layer, shown with 3.0mm and 4.5mm depth markers.

When Is the Ultherapy-Thermage Combination Unnecessary?

When only one layer is the problem. If your concern is pores and fine lines without sagging, Thermage alone may be enough. If your texture is fine but your jawline is blurring, Ultherapy alone may do the job.

For younger patients whose concerns center on pores and fine lines, Thermage FLX alone is the more sensible choice. If your skin texture is good but your jawline and double chin are the concern, it’s fine to start with Ultherapy PRIME alone. Combining them is the next step once both layers have started to sag.

In the maintenance phase, you don’t need both every time. Depending on your degree of aging, you can set a 6-month or 1-to-2-year cycle and alternate: Ultherapy one time, Thermage the next. This spreads out the recovery burden and lets you focus on whichever layer has sagged more at that point.

A different combination suits some people better. Accent Prime (the clinic’s “TuneFace” program), which delivers radiofrequency and ultrasound from a single device, provides relatively gentle heat stimulation. It can be a good fit if you want less discomfort and prefer maintenance on shorter cycles. It’s not that one is better than the other. The choice depends on which layer of your skin has sagged and how much. That call is made after a dermatologist’s diagnosis.

Brand mood image

Frequently Asked Questions

Do Ultherapy and Thermage have to be done on the same day, or can I split them?

You can split them. Because the two treatments work on different layers, they can be done back to back on the same day or spaced a few weeks apart. If your skin is thin or sensitive, or you have little time to recover that day, splitting the sessions is easier on you. I schedule the second session for after the reaction from the first has settled.

If I get Ultherapy and Thermage together, can I reduce the shot count for each?

Dividing the work lets us adjust some of the shots in overlapping areas. For example, we can trim the Thermage shots that would be repeated along the jawline, or the Ultherapy shots that would go into fine-line areas. But each device needs a certain number of shots to work in its layer, and cutting back indiscriminately leaves both treatments underpowered. The shot count is planned based on your skin thickness and degree of sagging.

After combining Ultherapy and Thermage, when do results appear and how long do they last?

A light tightening comes first, right after Ultherapy. Visible changes begin around week two, followed by a collagen response over several months. Contours take shape first, then the skin firms up behind them. How long results last depends on your degree of aging and lifestyle, so maintenance is scheduled every 6 months to every 1 to 2 years.

Is the pain worse when combining Ultherapy and Thermage than when getting each separately?

The pain of each treatment itself doesn’t increase, but when they’re done back to back on the same day, fatigue builds and the second treatment can feel more sensitive. That’s why I do the more intense Ultherapy first and allow plenty of numbing cream, cooling, and rest in between. If you’re sensitive to pain, splitting the sessions eases the burden. Pain and recovery for each treatment are covered in Thermage vs. Ultherapy: The Real Difference, From How They Work to What They Target.

After the Ultherapy-Thermage combination, when can I get my next treatment, and what should it be?

For lifting treatments that target the same layers, we wait and observe over the several months it takes for the collagen response to settle before planning the next step. Treatments that work on different layers can follow right away. A skin booster like Rejuran (PN / salmon DNA) works on a different layer, so it can be done even immediately after radiofrequency treatment. For fillers and botulinum toxin, the order depends on the area and the goal, so I recommend deciding on your next treatment in a one-on-one consultation once your skin has been assessed.

References

Written and medically reviewed by: Dr. Byeongsu Kim, Director · board-certified dermatologist

This content is for medical information only and does not replace diagnosis or treatment. Results and responses may vary by individual.

Consultation
Curious which treatment suits you best?
Book a 1:1 Consultation